A cheap dolly for your GoPro (incl. video)

How to make a dolly for a few bucks…

The solutions is pretty simple!

Components:

– Two skateboard trucks, with their 8 screws and nuts (you should have 4 “big nuts with nil-stop” for the wheels and 8 smaller with nil-stop too for the trucks)

– 8 spacer (small!!!)

– 4 inline wheels with the best ball bearing you can find. Wheels have to be quite soft, to minimize the noise and vibrations

– 1 tool used by the plasterers to put mortars or plaster on the walls (if you’ve got the right name, feel free to put it in the comment section below)

– 1 screwdriver and a drilling machine

How-to:

1. Drill 8 holes in the plasterers tool exactly as they are setup on the skateboard trucks, 4 on each side of the handle (see picture that will be added in a near future…) Please note that the wheels trucks shall be put as apart as possible…

2. Insert 8 screws.

3. Insert the spacer on each screw and put the smaller nuts in place. Tighten all these nuts.

4. Unscrew the biggest nut you will find on the truck axis.

5. Rotate the two trucks by 180 degrees.

6. Put back in place the “biggest nuts”. (tighten quite well, you do not want the truck to move freely)

7. Put the wheels in place, and tighten the “wheel nuts”. (not too much: the rule is tighten until the wheel can just not roll free, then unscrew a quarter of turn (90 degrees))

8. Put your GoPro seat post or roll bar system on the handle (depending on the diameter of the handle).

9. Put the GoPro Camera in place.

10. Go filming horizontal translations, straight or in curved trajectories, even circling around an object! Please note that it works best on smooth surfaces.

As I have readers that might well be willing to try to build this, please do this at your own risks, I am not liable to any accident, injuries or death caused by the dolly, its manufacturing or its use… 😉

 

Here is a video I just made: my GoPro Hero (with its wireless video link for FPV attached) is filmed by my Hero 2 which is filmed by my Canon Ixus 130 on a small Manfrotto tripod.

[wpvideo 1GbSEgXE]

TIP: Tipp-Ex dots on longest screws

Dear reader,

A simple idea to pick the right screw every time…

You know, these are looking almost the same, but one is longer, in order to let you fix the extenders under the case… (or any accessories)

So to identify them for sure, I just added a small white dot of “TIPP-EX” TM (or from your wife’s French manicure set!) on the longest screws.

Using this simple tip (TIPP-EX? joke inside) I do not make any more the mistake!

Some pics of this are here:

White Dots on the GoPro Screws
White Dots on the GoPro Screws top view

 

 

 

 

 

 

 

 

 

 

 

White dots on the side of the screw
White dots on the side of the longest screw

 

 

 

 

 

 

 

 

 

 

 

White dots on the top of the longest screw
White dots on the top of the longest screw

LOST! : GoPro Camera in TN, USA

Help Chris to get his camera back!

I lost my GoPro while rafting down the Ocoee River in Ducktown, TN.The view would have been from the guide’s perspective and there were only four of us in the boat.

The camera was on a helmet strap. It came off during a bad flip at Hell Hole, right before the take out….

Reward if found!

PLEASE USE THE FORM located in the contact section (on top of the page) if you have any info on this Lost GoPro. (or comment…)